Biobriket Dari Limbah Abu Batu Bara Sisa Pembakaran PLTU Dan Serbuk Penggergajian Kayu dengan Perekat Kertas Bekas

Myson Myson

Abstract


This research aims to reduce waste and process it into briquettes so that it produces energy that can be utilized by many people. Bottom ash from the rest of coal burning for PLTU, used paper from offices and education activities and sawdust along the banks of the Batanghari river, especially across the city of Jambi, are waste that will be utilized. The three initial compositions are determined to obtain the calories produced from the briquettes made. From the laboratory test results, it is obtained that heating values are in the range of 2500 to 2800 kcal / kg. These results are not satisfactory and still need to change the composition between sawdust, coal ash and waste paper in order to obtain a calorific value that corresponds to the calorific value produced by LPG gas.

Keywords


Biobriquette, waste, heat

Full Text:

PDF

References


Aji, Setyo.B dan Anjar. 2009. The Role Of a Coal Gasification Fly Ash as Clay Addive in Building Ceramic. Journal of the European Ceramic Sosiety 26 (2006) 3783-3787.

Hasan Basri, Dr.Ir, 2007, ‘ Teknik Kogenerasi (bahan kuliah),PPs Unsri, Palembang.

Moran, J Michael & Shapiri N Howard,1999,”Fundamental Engineering Thermodynamics”, fourth edition, Jhon Wiley

Nelly, Komang Sundari 2010. Pengaruh Perlakuan Suhu Bakar Pada Massa Bodi Keramik Stone Kode BL 1 Terhadap Parameter Penyusutan dan Peresapan Air. Bali: Skripsi.

Prayitno, Dody. Teknologi Rekayasa Material. Jakarta: 2010

Reynold, C William & Perkins C Henry, 1977,”Termodinamika Teknik”, Alih Bahasa Filino Harahap, 1982, Erlangga

Roger Kinsky M.Eng,Sc.,B.E.,B.Sc, ‘Applied Heat’,An Introduction to thermodynamics, Second edition.

Sheth, P.N and Babu, B.V.2006.”Kinetic Modeling of the Pyrolysis of Biomass, Procedings of National Conference on Environmental Conservation”, 453-458

Suasmoro, Dr. 2000. Fisika Keramik. Surabaya. Jurusan Fisika FMIPA ITS.

Subiyanto, Hari Subowo. 2003. Pengaruh Temperatur Sintering terhadap Sifat Mekanik Keramik Insulator Listrik. Surabaya: ITS.

Surdia, Tata dan Kenji Chijiwa. Pengetahuan Bahan Teknik. Jakarta: Pradya Paramita, 2006.

Teodora Deac, Tutunaru, L.F, Ferenc Gaspar.,2016,”Environmental Impact of Sawdust Briquettes Use- Experimental Approach”.Technical University of Cluj-Napoca. Faculty of Mechanical Engineering: Romania.

Van Vlack, Lawrence. H. 2004. Elemen – Elemen Ilmu Dan Rekayasa Material. Jakarta: Erlangga Adrian Bejan, 1988, ‘Advanced Engineering Thermodynamics’, Jhon Wiley&son.Inc

Zul Fahmi 1, Rr. Harminuke Eko Handayani 2, Syarifudin,” PENGARUH PENGGUNAAN BOTTOM ASH DRY DAN SLAG LIMBAH GASIFIKASI BATUBARA PADA PEMBUATAN BATAKO TERHADAP KUAT TEKAN”, JP Vol.1 No.2 Februari 2017 ISSN 2549-1008




DOI: http://dx.doi.org/10.33087/civronlit.v5i2.71

Refbacks

  • There are currently no refbacks.


Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

Jurnal Civronlit Unbari
Publisher: Fakultas Teknik Universitas Batanghari Jambi
Jl. Slamet Ryadi, Broni-Jambi, Kodepos: 36122, Phone: 0741-668280, email: civronlit.unbari@gmail.com

Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.